Lower Bearing Carrier Puller Replacement for Yamaha, Johnson, Evinrude, Mercury, Honda, Mercruiser, for Most Gearcases 115hp and Above with Adjustable Arms

Lower Bearing Carrier Puller Replacement for Mercruiser Lower Bearing Carrier Puller Replacement for HondaLower Bearing Carrier Puller Replacement for YamahaLower Bearing Carrier Puller Replacement for Evinrude JohnsonLower Bearing Carrier Puller Replacement for MercuryLower Bearing Carrier Puller Replacement for Most Gearcases 115hp and above with Adjustable ArmsInstallation Instructions:1. Clamp two L-shaped hooks on the edges of both sides of the bearing, ensuring that the hooks are tightly attached to the bearing without any signs of looseness. 2. Fixing fixture: place the H-type fixture on the threaded rod, and then adjust the position of the fixture so that its two ends are connected with the ends of two hooks respectively. Tighten and secure the entire device by tightening the screws on the fixture. 3. Connect the threaded rod: Align the end of the threaded rod with the center hole of the bearing, rotate the threaded rod gradually until the front end of the threaded rod presses against the axis of the bearing.Note:1. Apply force slowly and evenly, using a wrench to rotate the center screw clockwise slowly and steadily.2. Pay close attention to the condition of tools and bearings. If you hear abnormal noise or feel an abnormal increase in resistance, stop immediately and check if the tool is installed correctly.3. If the bearing is stuck, do not apply excessive force to avoid damaging the puller or shaft.Package Included:1*Lower Bearing Carrier Puller

• Lower Bearing Carrier Puller Replacement for Mercruiser, Replacement for Honda
• Lower Bearing Carrier Puller Replacement for Yamaha, Replacement for Evinrude
• Specially designed for quick disassembly of the bearing seat
• Package Included 1*Lower Bearing Carrier Puller
• We provide you with thoughtful service throughout the entire process